Portable ECScope is a hand-held battery operated device to simultaneously monitor 7 lead ECGs. 6 repetitive measurements with chest lead at V1 to V6 provides a 12 lead ECG printout.

It can also simultaneously monitor 12 lead ECGs using 5 to 12 lead algorithm.

It is ideal for operation in general physician's office or in mobile telemetry.

Data acquisition

No. of leads acquired:	7 Leads simultaneous (Conventional mode)
	12 Leads simultaneous (5 -12 mode)
Leads acquired (Conventional mode):	I, II, III, aVR, aVL, aVF and V
Leads acquired (5 -12 mode):	I, II, III, aVR, aVL, aVF, V1,V2,V3,V4,V5 and V6
Lead and gain selection:	User can dynamically select lead/gain during recording
Digital sampling rate:	200 samples/sec (5ms samples)

Patient information

Input at the start of the measurement

Help facility

Is available at any time on the display

Data Display

Displayed in color touch screen

ECG Monitoring and Recording

The ECG signals are displayed in real time on the LCD screen of the Portable ECScope.

The display also shows

ECG lead selection   ECG gain selection   Heart Rate   ECG strips record option

Data storage capability

Permanent storage of 200 patient records More than 2000 patient records can be stored in Dyansys   USB memory key Data can be transfered to a PC via the USB memory key

Printing capability

Direct Print out through the attached printer on a single A4   sheet in plain or graph paper Print out using PC through Dyansys Print Tool Support 10 seconds Rhythm Print out Print out included Patient demographics, Doctors details,   12 Lead ECG graphs in format - 6 x 2 1R, 4 x 3 1R Email option using Dyansys Print Tool

Regulatory compliance

IEC 60601-1, IEC 60601-1-1, IEC 60601-1-2, IEC 60601-1-4 and IEC 60601-2-27

FDA Approved *

Patient safety

Patient leakage current: <10 uA Classified as Class II - Type CF device as per IEC requirements Protected from patient defibrillation

Product test and calibration

Extended tests and calibration can be performed including the   ECG cable by connecting the ECG cables to calibration terminals provided in the product

Power specifications

AC adapter input 230 V AC adapter output 12V DC @ 2amps Max Power Consumption <15W

Physical specifications

Weight <0.4 Kgs (including the battery) A Dimensions 175 x 95 x 112 (mm)

Environmental specifications

Operating temperature 0°C to 45°C Storage Temperature –20°C to +65°C Humidity 10% to 95% Pressure 700 -1060 millibars

Battery and charger

Battery pack type NiMH rechargeable battery Battery voltage 3.6 VDC Battery capacity 2500 mAh Typical battery operational >6 hours   time on full charge: (without any peripherals connected)   Typical battery charge time 6 hours

Printer supported

HP 5168

ECG Electrodes

Use DyAnsys Electrodes for high signal quality

ECG Cable

5 lead ECG cable with locking connector